WiFi Hotspot using command line

A WiFi Hotspot is a Wireless hub which offers a network access to various devices over a wireless medium using routers. It requires a particular software which gives the ability to host a Hotspot in our computer. In order to reduce the difficulty, it’s better to establish a WiFi Hotspot using Command line.

Below are the steps:

-open command using administrator.

-type netsh wlan show drivers (to check whether the computer supports the Hosted network or not)

-if yes than type netsh wlan set hostednetwork mode=allow ssid=yourname key=yourpassword 

-after that type netsh wlan start hostednetwork

- Open Control Panel and go to Network and Sharing Center.

- Click Change Adapter Settings.

- Right click your Internet connection and select Properties.

- Click the Sharing tab.

- Check the box that says Allow other network users to connect.

- Choose your virtual Wi-Fi adapter and click OK.